ToolPatch

One page. One job. Done.

← Back to all tools

Conversion Unit conversion

Length/Distance Converter

Convert between metric and imperial length units.

Conversion

Length/Distance Converter converts one source length into millimeters, centimeters, meters, kilometers, inches, feet, yards, miles, and nautical miles. It is useful when you need a focused distance conversion table rather than a single pairwise conversion. Enter the value and source unit, then review every target unit at once so the result can be copied into drawings, navigation notes, reports, or planning calculations with the original input preserved.

Permalink

Input guidance

Enter the source value, select source and target units where available, then review conversion factors and displayed rounding before copying the result.

How to use this tool

Enter the source length or distance value.
Select the unit that the source value is currently measured in.
Run the conversion and review the metric, imperial, and nautical outputs.
Copy or share the result together with the source value and source unit so it can be reproduced later.

Length/Distance Converter

Convert between metric and imperial length units.

Results

Metric:

Millimeters: 100000.000 mm

Centimeters: 10000.000 cm

Meters: 100.000 m

Kilometers: 0.100000 km

Imperial:

Inches: 3937.008 in

Feet: 328.084 ft

Yards: 109.361 yd

Miles: 0.062137 mi

Nautical Miles: 0.053996 nmi

Formula or method

Applies fixed conversion factors between the supported source and target units, then rounds displayed values for readability.

How to interpret the result

Confirm the source unit, target unit, conversion factor, and displayed rounding before copying the result.

Review note and limitations

Converted values depend on the selected units, conversion factors, and displayed rounding.
Some domains use conventions or reference conditions that may differ from a simple unit conversion.

Related tools and workflows

Related conversion tools help verify neighboring units, dimensions, rates, or reference values before copying a converted result. Start with Angle Converter, Cooking Measurements Converter, and Data Size Converter when you need a quick follow-up check.

Angle Converter

Convert angles between deg, rad, and grad.

Cooking Measurements Converter

Convert kitchen volume units like tsp, tbsp, cups, ounces, pints, and liters.

Data Size Converter

Convert data sizes across bytes, KB, MB, GB, and TB.

EBCDIC Converter

Convert text to EBCDIC hex and vice-versa.

Energy Converter

Convert energy units: J, kJ, cal, kcal, Wh, kWh, and BTU.